[KLUG Members] Network Card
Adam Tauno Williams
members@kalamazoolinux.org
13 Jul 2001 12:32:00 -0400
>I have just installed Red Hat 7.1 on my new gateway solo 9300 laptop. And
>the install went wonderfully! Not a problem! But, and there is always a
>but, i cant get it to notice my Xircom RealPort Ethernet 10/100+Modem...
What is the model of the card (usually written on the bottom side of the
card)?
>Which is why i installed linux on this comptuer anyway, so i can use it at
>school! But anyway! Here my question, how do i get linux to reconize that
>my netowork card is installed? I had the card in there durring the whole
>installation, and during startup. Are there some drivers or something i
>need to load? And if so, where can i get those? thank you!
Are the PCMCIA modules loaded?
Did you check out
"http://lhd.datapower.com/db/dispproduct.cgi?DISP?282"?
If you take the card in and out does the machine beep?
What does /proc/pci say?