[KLUG Members] SCSI & RH7.2

[Robert Pfeiffer]

Hi all,

I'm trying to install a SYBIOS SYM53c413 SCSI card on a linux RH 7.2 
Kernal 2.4.7-10 box that was setup a while ago. I was under the 
impression that linux now autodetects hardware?  I didn't see a HOWTO 
install a SCSI card to go through.  Just info on the SCSI programming.

I looked under /proc/isapnp and this is the entry for the scsi board.
I have a 53c416.o under /modules, so I'd assume that it would find the 
right module and loaded it at boot.  I'm used to the conf.modules, which 
I can't find under rh7.2. Any help would be appreciated?

Card 1 'SLI4161:SYM 53C416' PnP version 1.0 Product version 0.1
   Logical device 0 'SLI4163:Unknown'
     Supported registers 0x2
     Device is not active
     Resources 0
       Priority preferred
       Port 0x200-0xffe0, align 0x1f, size 0x20, 16-bit address decoding
       IRQ 4,5,7,10,11,12,15 High-Edge