[KLUG Members] After adding IDE drive system doesn't boot

[adam at morrison-ind.com]

> Try swapping the ServeRAID / IDE cards such that the current top/bottom are
> reversed. Motherboard BIOS usually picks either the first/last found bootable
> controller to boot from, so swapping the card order swaps the scan order and
> hopefully boots from RAID once again.

Yep, that did it.  Apparently the 32-bit PCI slots are bus 0 and the 
64-bit PCI
slots are bus 1.  So I had to stick the IDE card in a 64-bit slow, then it
worked (But what a waste!).